ALL200RMINSTALLATION INSTRUCTIONSAladdin Light Lift, Inc. (256) 429-970061 Shields Road (877) 287-4601Huntsville, AL 35811 www.aladdi
STEP 13After turning o power, remove and discard existing electrical box if present in ceiling. Only use ceiling box provided with ALL200RM.Never re
STEP 17Attach conduit assembly to 3/4” conduit connector mounted below chandelier pulley. Once completely inserted, tighten set screw on conduit conn
STEP 20Loosely fasten chandelier pulley assembly to suitable structure using 7/16” x 4” hex tap bolts, 7/16” nylon lock nuts and 3/8” USS at washers.
STEP 22Shim and adjust chandelier pulley assembly so that winch cable hangs plumb through center of hole in top contact plate on ceiling box. See Dia
STEP 25Turn o supply power before wiring ALL200RM light switch. Turn o light switch in square box. Wire light switch with 110V wiring. e 110V li
STEP 26Run controller wire in to single gang box for Keyswtich Controller or optional SmartLift Controller. Chandelier must be visible from controll
STEP 31Fully thread screw collar loop or threaded stem that was supplied with chandelier to 1/4 IPS xture coupler. If chandelier was supplied with a
STEP 34Adjust canopy and telescopic conduit assembly so contact plates meet before the canopy touches the ceiling.See Diagram R.Never allow the chande
STEP 38Tighten xture coupler set screws using supplied 3/32” Allen wrench. Fixture coupler set screws have thread lock already applied at factory.
STEP 41Conrm winch cable still hangs plumb through center of hole in top contact plate on ceiling box. See STEP 22 and Diagram M.STEP 42Operate ALL2
Read the following guidelines prior to installing the ALL200RM:I. e ALL200RM must be installed by a licensed, bonded, and insured electrician. II.
ALL200RM TROUBLESHOOTING GUIDETECH SUPPORT: (877) 287-4601 Monday through Friday 8:00am to 4:00pm CSTI. Troubleshooting and installation must be perf
ALL200RM TROUBLESHOOTING GUIDE cont. 1. Conrm ALL200RM is at the CEILING POSITION. If not, use the controller to operate the ALL200RM to the CEILIN
Warranty AgreementAladdin Light Lift, Inc. warrants its chandelier light lift unit for one year from the date of purchase. e warranty includes all p
ALL200 RM Hardware Box List5/16” USS Flat Washers (QTY 4)3/8” x 1¼” Hex Tap Bolts (QTY 2)Flat Brackets (QTY 2) per directional pulle
STEP 1Determine mounting location of ALL200RM motor assembly. e ALL200RM may be mounted on an angle, vertically, horizontally or upside down, if sec
STEP 3Determine mounting location of directional pulleys if they are to be installed with ALL200RM. Directional pulleys can be used to change winch c
STEP 6Position ALL200RM motor assembly where it will be mounted. Adjustments can be made loosening 3/8” channel strut bolts that hold ALL200RM motor
STEP 8Turn o supply power before wiring ALL200RM motor switch. Turn o motor switch in square box. Wire motor switch with 110V wiring. e 110V moto
STEP 9Remove dust cover and remove paper tape from winch drum while keeping tension on winch cable.Never operate the ALL200RM without tension on the c
Diagram HRemove Dowel Pin Grooved End FirstInsert Dowel Pin Smooth End FirstFixture CouplerTemporary WeightBottom Contact Plate AssemblyWinch Cable
Commentaires sur ces manuels