ALL700-3300W INSTALLATION INSTRUCTIONSAladdin Light Lift, Inc. (256) 429-970061 Shields Road (877) 287-4601Huntsville, AL 35811 www.
STEP 23Adjust screw collar rings so top of canopy is just below edge of bottom contact plate. Canopy should be at least 1 ¾” deep. See Diagram I.Neve
STEP 27Tighten xture coupler set screws using supplied 3/32” Allen wrench. Fixture coupler set screws have thread lock already applied at factory. S
ALL700 TROUBLESHOOTING GUIDETECH SUPPORT: (877) 287-4601 Monday through Friday 8:00am to 4:00pm CSTI. Troubleshooting and installation must be perfor
ALL700 TROUBLESHOOTING GUIDE cont. 1. Conrm ALL700 is at the CEILING POSITION. If not, use the controller to operate the ALL700 to the CEILING POSI
Read the following guidelines prior to installing the ALL700:I. e ALL700 must be installed by a licensed, bonded and insured electrician. II. e ALL
STEP 1Determine where ALL700 will mount on ceiling joists. ALL700 must be installed level, in an accessible location directly above chandelier.Never
STEP 5Attach the 1/2” conduit connector on ceiling box to bottom of conduit assembly. Once completely inserted, tighten set screw on conduit connecto
STEP 7Position ALL700 where ceiling box will be centered in ceiling hole. Weight and bottom contact plate assembly should hang down through ceiling h
STEP 9Shim and adjust ALL700 so that winch cable hangs plumb through center of hole in top contact plate on ceiling box. See Diagram E. Look up at c
STEP 11Turn o supply power before wiring ALL700. Turn o motor switch in square box. Wire motor switch with 110V wiring. e 110V motor feed must be
STEP 13Remove dust cover and remove paper tape from winch drum while keeping tension on winch cable.Never operate the ALL700 without tension on the ca
STEP 20Fully thread screw collar loop or threaded stem that was supplied with chandelier to 3/8 IPS xture coupler. If chandelier was supplied with a
Commentaires sur ces manuels