Aladdin-light-lift ALL200RM-CM-240V Manuel d'utilisateur télécharger pdf (Page 17)

STEP 34

Adjust screw collar rings so top of canopy is just below edge of bottom contact plate. Canopy should be at

least 4.4cm deep. See Diagram R.

Never allow the chandelier canopy to make contact with the ceiling before the contact plates meet. is

could interfere with the automatic shuto system and could cause the chandelier to fall, which could

cause death, personal injury, and/or property damage.

STEP 35

Loosen bottom screw collar ring to allow easy wire access. See Diagram R.

STEP 36

Run chandelier wires through screw collar or threaded stem and pull through xture coupler holes. See

Diagram R.

STEP 37

Wire nut chandelier hot wire to black bottom contact plate wire, other hot to white, and protective earth to

green. If the chandelier has two hot wires, wire extra hot to red wire. See Diagram R. Protective earth wire

from chandelier can not touch underside of bottom contact plate. A direct short will occur.

Diagram R

Top of Canopy

Just Below Edge

of Bottom

Contact Plate

4.4cm Deep

Canopy

Wire Nut Chandelier

Wires to Bottom

Contact Plate Wires

Bottom Screw

Collar Ring

Pull Chandelier

Wires rough

Screw Collar Loop/

readed Stem and

Fixture Coupler

1 2 ... 12 13 14 15 16 17 18 19 20 21

Pas de commentaire

Aladdin-light-lift ALL200RM-CM-240V Manuel d'utilisateur Page 17