Aladdin-light-lift ALL200RM-CM-240V Manuel d'utilisateur télécharger pdf (Page 4)

STEP 1

Determine mounting location of ALL200RM motor assembly. e ALL200RM may be mounted on an

angle, vertically, horizontally or upside down, if secured properly. See Diagram A.

Never install the ALL200RM where the ceiling height and total cable run through the pulleys exceeds

1.5 meters less than the exact length of winch cable. For example, if the ALL200RM is equipped with a

65ft(19.8m) cable do not install the ALL200RM with a ceiling height and total cable run that is greater

than 60ft(18.3m). is could cause the cable to become reverse wrapped on the winch. An ALL200RM

installed with a reverse wrapped cable could cause the chandelier to fall, which could cause death,

personal injury, and/or property damage. Winch cable length can be found on the ALL200RM product

sticker, shipping box, and the front page of these installation instructions.

STEP 2

Determine mounting location of chandelier pulley assembly. Chandelier pulley assembly must be mounted

directly above where chandelier will hang. See Diagram B.

Never mount the chandelier pulley assembly o plane or unlevel in a remote installation. is could

cause the chandelier to fall, which could cause death, personal injury, and/or property damage. e

winch cable must hang plumb through the center of the top contact plate on the ceiling box.

Level

Upside Down

Left Angle

Right Angle

Vertical

Diagram A

Diagram B

Chandelier Pulley

Assembly Height is

Adjustable

From 29.2cm to 41.9cm

If Ordered With

Conduit Cut to

Minimum

Chandelier Pulley

Assembly Height

is Adjustable

From 19.7cm to

23.5cm

34.9cm Minimum

40.6cm Maximum

1 2 3 4 5 6 7 8 9 ... 20 21

Pas de commentaire

Aladdin-light-lift ALL200RM-CM-240V Manuel d'utilisateur Page 4