Aladdin-light-lift ALL200RM-CM(Two Circuit Fixtures Only) Manuel d'utilisateur télécharger pdf (Page 10)

STEP 13

After turning o power, remove and discard existing electrical box if present in ceiling. Only use ceiling box

provided with ALL200RM.

Never remove an existing ceiling box while the power is connected. Electricity could cause death,

personal injury, and/or property damage.

STEP 14

Cut a 4 1/2” hole in ceiling for ceiling box. If you removed an existing ceiling box, existing hole may need to

be enlarged.

STEP 15

Tighten temporary weight to xture coupler on bottom contact plate. Make sure jam nut on weight is tight.

Never install or operate an ALL200RM before securing the temporary weight to the xture coupler.

is could cause the temporary weight to fall, which could cause death, personal injury, and/or property

damage.

STEP 16

Fasten side brackets to chandelier pulley bracket using 3/8” x 1¼” hex tap bolts, 3/8” nylon lock nuts, and

5/16” USS at washers. See Diagram I.

Diagram I

3/8” x 1¼” Hex Tap Bolts

5/16” USS Flat Washers

3/8” Nylon Lock Nuts

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Pas de commentaire

Aladdin-light-lift ALL200RM-CM(Two Circuit Fixtures Only) Manuel d'utilisateur Page 10