Aladdin-light-lift ALL700-CM-240V Manuel d'utilisateur télécharger pdf (Page 11)

STEP 27

Tighten xture coupler set screws using supplied 3/32” Allen wrench. Fixture coupler set screws have

thread lock already applied at factory. See Diagram K.

STEP 28

Apply supplied liquid thread lock (part D) to all ttings including xture coupler and screw collar loop

ttings.

Never attach the chandelier to the ALL700 improperly. Failure to secure the xture coupler set screws

and properly apply thread lock could cause the chandelier to fall, which could cause death, personal

injury, and/or property damage.

STEP 29

Replace canopy and bottom screw collar ring. Conrm top of canopy is just below edge of bottom contact

plate. See Diagram K.

Never allow the chandelier canopy to make contact with the ceiling before the contact plates meet. is

could interfere with the automatic shuto system and could cause the chandelier to fall, which could

cause death, personal injury, and/or property damage.

STEP 30

Conrm winch cable still hangs plumb through center of hole in top contact plate on ceiling box. See

STEP 9 and Diagram E.

STEP 31

Operate ALL700 to the CEILING POSITION. Test lights and call Aladdin Light Lift (877) 287-4601

with any questions regarding installation and/or operation of ALL700.

Bottom Screw Collar Ring

Canopy

Tighten Set

Screws with

3/32” Allen

Wrench

Top of Canopy

Just Below Edge

of Bottom

Contact Plate

Diagram K

1 2 ... 6 7 8 9 10 11 12 13

Pas de commentaire

Aladdin-light-lift ALL700-CM-240V Manuel d'utilisateur Page 11