Aladdin-light-lift ALL200-CM-240V Manuel d'utilisateur télécharger pdf (Page 2)

Read the following guidelines prior to installing the ALL200:

I. e ALL200 must be installed by a licensed, bonded and insured electrician.

II. e ALL200 must be installed level, in an accessible location and directly above the chandelier.

III. oroughly read, understand and follow each step and safety warning in the ALL200 installation

instructions and orange safety precautions supplement.

IV. During installation of the ALL200, take one step at a time and check o each step upon completion.

V. e Troubleshooting Guide is located in the back of the Installation Instructions. Call Aladdin Light

Lift (877) 287-4601 if assistance is needed for installation and/or operation of the ALL200. Refer to the

Keyswitch Controller Guide or Smartlift Controller Guide for operation instructions.

VI. Ignoring any safety warnings and/or symbols not only voids the warranty, but may cause death, personal

injury and/or property damage.

VII. e wattage of the chandelier can not exceed the wattage capacity of the ALL200.

VIII. e Warranty Agreement is located on the last page of Installation Instructions.

IX. Give all Aladdin paperwork to property owner and/or anyone that will be using ALL200.

ALL200 Parts Bag List

A. #10 x 1 ¼” Pan Phillips-Wood Screws (QTY 4)

B. 3/16” x 1” Fender Washers (QTY 4)

C. Screw Collar Ring (QTY 1)

D. read Lock (QTY 1)

E. 3/32” Allen Wrench (QTY 1)

1/8 IPS(10mm) x 1/4 IPS(13mm) Fixture Coupler (QTY 1)

F. 1/4 IPS(13mm) x 3/8 IPS(16mm) Fixture Coupler (QTY 1)

1/4 IPS(13mm) x 1/2 IPS(22mm) Fixture Coupler (QTY 1)

1 2 3 4 5 6 7 ... 12 13

Pas de commentaire

Aladdin-light-lift ALL200-CM-240V Manuel d'utilisateur Page 2