Aladdin-light-lift ALL200-CM-240V Manuel d'utilisateur télécharger pdf (Page 9)

STEP 20

Fully thread screw collar loop or threaded stem that was supplied with chandelier to 1/4 IPS(13mm) xture

coupler. If chandelier was supplied with a 1/8 IPS(10mm), 3/8 IPS(16mm), or 1/2 IPS(22mm) screw collar

loop or threaded stem, see attached parts bag on cover to obtain proper sized xture coupler. If the screw

collar loop or threaded stem supplied with chandelier does not properly t, contact chandelier manufacturer

or Aladdin Light Lift (877) 287-4601 to obtain proper coupler. See Diagram H.

Failure to insure your xture is properly mated to the xture coupler could cause the chandelier to fall,

which could cause death, personal injury, and/or property damage.

Never hang a chandelier from an ALL200 using anything but the Aladdin Light Lift supplied xture

coupler, bottom contact plate, and dowel pin. is could cause the chandelier to fall, which could cause

death, personal injury, and/or property damage.

STEP 21

Attach chandelier canopy to screw collar loop using screw collar rings on both top and bottom. An extra

screw collar ring (part C) is supplied in parts bag. See Diagram H.

Screw Collar Rings

1/4 IPS(13mm) Fixture

Coupler

readed Stem/Screw Collar

Loop Supplied with

Chandelier

STEP 22

Adjust chandelier chain to desired length and attach to screw collar loop.

Never cut, modify, or adjust the winch cable and never install an ALL200 with a cut, modied or

adjusted winch cable. Adjust the chandelier elevation by adjusting the chandelier chain or stem. An

ALL200 installed with a cut, modied, or improperly adjusted cable could cause the chandelier to fall,

which could cause death, personal injury, and/or property damage.

Diagram H

Canopy

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Aladdin-light-lift ALL200-CM-240V Manuel d'utilisateur Page 9