Aladdin-light-lift ALL200RM-CM Manuel d'utilisateur télécharger pdf (Page 15)

STEP 26

Run controller wire in to single gang box for Keyswtich Controller or optional SmartLift Controller.

Chandelier must be visible from controller location.

STEP 27

If using a Keyswitch Controller instead of a SmartLift Controller, secure key cylinder to cover plate using

supplied keyswitch nut.

Plug controller to controller wire. Use supplied cover plate screws to attach controller to single gang box.

STEP 28

Test motor and automatic shut-o system of ALL200RM. For operation instruction, reference Keyswitch

Controller Guide or SmartLift Controller Guide, then follow below:

Operate ALL200RM down a few inches. Operate ALL200RM up to CEILING POSITION. When

ALL200RM pulls bottom contact plate and temporary weight to the CEILING POSITION, the motor

will, if installed and adjusted properly, shut o by itself.

Call Aladdin Light Lift (877) 287-4601 if ALL200RM does not shut o at CEILING POSITION.

Never extend the full length of winch cable from the ALL200RM. is could cause the cable to become

reverse wrapped on the winch. An ALL200RM installed with a reverse wrapped cable can cause the

chandelier to fall, which could cause death, personal injury, and/or property damage. Refer to the

Keyswitch or SmartLift Controller tag for correct operating instructions. Winch cable length can be

found on the ALL200RM product sticker, shipping box, and on the front page of these installation

instructions.

STEP 29

Operate ALL200RM to the DOWN POSITION. Temporary weight should be at desired elevation to

install chandelier.

STEP 30

Holding tension on winch cable, unscrew temporary weight from xture coupler.

Never operate the ALL200RM without tension on the cable. is could cause the cable to wind o the

winch drum and get damaged. A damaged cable could cause the chandelier to fall, which could cause

death, personal injury, and/or property damage.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Aladdin-light-lift ALL200RM-CM Manuel d'utilisateur Page 15