Aladdin-light-lift ALL200RM-CM Manuel d'utilisateur télécharger pdf (Page 17)

STEP 34

Adjust canopy and telescopic conduit assembly so contact plates meet before the canopy touches the ceiling.

See Diagram R.

Never allow the chandelier canopy to make contact with the ceiling before the contact plates meet. is

could interfere with the automatic shuto system and could cause the chandelier to fall, which could

cause death, personal injury, and/or property damage.

STEP 35

Loosen bottom screw collar ring to allow easy wire access. See Diagram R.

STEP 36

Run chandelier wires through screw collar or threaded stem and pull through xture coupler holes. See

Diagram R.

STEP 37

Wire nut chandelier hot wire to black bottom contact plate wire, neutral to white, and ground to green.

If the chandelier has two hot wires, wire extra hot to red wire. See Diagram R. Bare ground wire from

chandelier can not touch underside of bottom contact plate. A direct short will occur.

Diagram R

Wire Nut Chandelier

Wires to Bottom

Contact Plate Wires

Bottom Screw

Collar Ring

Pull Chandelier

Wires rough

Screw Collar Loop/

readed Stem and

Fixture Coupler

Bottom Contact

Plate Must Meet

Top Contact Plate

Before Canopy

Touches Ceiling

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Aladdin-light-lift ALL200RM-CM Manuel d'utilisateur Page 17