STEP 9
Remove dust cover and remove paper tape from winch drum while keeping tension on winch cable.
Never operate the ALL300RM without tension on the cable. Never remove or tamper with the cable
safety device. Never install an ALL300RM that has the cable safety device removed or tampered with.
e cable safety device consists of the limit switch and small gauge rectangular wire and is located
directly in front of the winch drum. Removing or tampering with the cable safety device could cause the
cable to become reversed wrapped on the winch and could also cause the cable to unravel o the winch
drum and get damaged. Never install or operate an ALL300RM that has a frayed, kinked, or otherwise
damaged cable. Never operate the ALL300RM without rst removing the paper tape from the winch
drum. Avoiding any of these could cause the chandelier to fall, which could cause death, personal injury,
and/or property damage.
STEP 10
Replace dust cover and locate controller wire. Controller wire is a low voltage, gray sheathed, four conductor
wire with white plugs on either end.
STEP 11
Plug controller to controller wire and operate motor down to extend winch cable to desired length for
installation. Do not operate motor up. Reference Keyswtich Controller or SmartLift Controller guide for
operation instruction. Keep tension on cable at all times.
Never extend the full length of winch cable from the ALL300RM. is could cause the cable to become
reverse wrapped on the winch. An ALL300RM installed with a reverse wrapped cable can cause the
chandelier to fall, which could cause death, personal injury, and/or property damage. Refer to the
Keyswitch or SmartLift Controller tag for correct operating instructions. Winch cable length can be
found on the ALL300RM product sticker, shipping box, and on the front page of these installation
instructions.
Never operate the ALL300RM without tension on the cable. Never remove or tamper with the cable
safety device. Never install an ALL300RM that has the cable safety device removed or tampered with.
e cable safety device consists of the limit switch and small gauge rectangular wire and is located
directly in front of the winch drum. Removing or tampering with the cable safety device could cause the
cable to become reversed wrapped on the winch and could also cause the cable to unravel o the winch
drum and get damaged. Never install or operate an ALL300RM that has a frayed, kinked, or otherwise
damaged cable. Never operate the ALL300RM without rst removing the paper tape from the winch
drum. Avoiding any of these could cause the chandelier to fall, which could cause death, personal injury,
and/or property damage.
STEP 12
Proceed to step 13 unless bottom contact plate must be removed. Follow Diagram H if and only if bottom
contact plate must be removed from winch cable. Diagram H must be followed precisely for proper
detachment and reattachment procedure. Diagram H is on next page.
Never stray from or alter the contact plate attachment/reattachment procedure. is could cause the
chandelier to fall, which could cause death, personal injury, and/or property damage.
Never detach the winch cable from the winch drum. is could cause the chandelier to fall, which could
cause death, personal injury, and/or property damage.
(21 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels