Aladdin-light-lift ALL700-CM Manuel d'utilisateur télécharger pdf (Page 5)

STEP 7

Position ALL700 where ceiling box will be centered in ceiling hole. Weight and bottom contact plate

assembly should hang down through ceiling hole. Adjustments can be made loosening 3/8” channel strut

bolts that hold ALL700 to channel struts. Retighten channel strut bolts after adjustments are made.

Conrm channel strut nuts are seated properly. See Diagram C.

Never adjust the channel struts improperly. is could cause the chandelier to fall, which could cause

death, personal injury, and/or property damage.

Conduit Coupler

Bottom Set Screw

3/32” Allen Wrench

STEP 8

Adjust ceiling box elevation up or down to be ush with sheetrock. Use 3/32” Allen wrench on conduit

coupler to loosen bottom set screw. Conduit assembly is telescopic. e ceiling box should not touch inside

of ceiling hole. Retighten bottom set screw on conduit coupler and conrm top set screw is tight. See

Diagram D.

Never attach or adjust the conduit assembly improperly. is could interfere with the automatic shuto

system and could cause the chandelier to fall, which could cause death, personal injury, and/or property

damage.

Diagram C

3/8” Channel Strut

Adjustment Bolts

3/8” Channel Strut

Adjustment Bolts

Diagram D

4 1/2” Hole

Conduit Coupler

Top Set Screw

3/32” Allen

Wrench

Sheetrock

1 2 3 4 5 6 7 8 9 10 ... 13 14

Pas de commentaire

Aladdin-light-lift ALL700-CM Manuel d'utilisateur Page 5