Aladdin-light-lift ALL700RM-CM Manuel d'utilisateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 22
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
STEP 22
Shim and adjust chandelier pulley assembly so that winch cable hangs plumb through center of hole in
top contact plate on ceiling box. See Diagram M. Look up at ceiling box from oor level to verify cable is
plumb.
Never install the ALL700RM where the cable is not plumb through the center of the ceiling box. is
could interfere with the automatic shuto system and could cause the chandelier to fall, which could
cause death, personal injury, and/or property damage.
STEP 23
Securely tighten chandelier pulley assembly hardware and verify that winch cable hangs plumb through
center hole in top contact plate on ceiling box. Look up at ceiling box from oor level to verify cable is
plumb. See Diagram M.
Conrm winch cable
hangs plumb through
center of hole in
top contact plate on
ceiling box.
Diagram M
View from Floor Level
STEP 24
Install directional pulleys to suitable structure using 7/16” x 3 ¼” bolts, 7/16” nylon lock nuts, and 3/8” USS
at washers as per Diagram N. Securely tighten hardware.
Never install directional pulleys without properly fastening them to the structure. is could interfere
with the automatic shuto system and could cause the chandelier to fall, which could cause death,
personal injury, and/or property damage.
Never install directional pulleys and/or the chandelier pulley assembly o plane. Never install
directional pulleys and/or the chandelier pulley assembly where there will be right and left hand turns in
the winch cable. is could damage the winch cable and could cause the chandelier to fall, which could
cause death, personal injury, and/or property damage. Make sure the winch cable travels straight to and
from the pulley grooves of each pulley. Make sure the winch cable is completely unobstructed between
pulleys.
Pulley
Quick Link
Flat Brackets
4”
7”
7/16” x3¼” Hex Tap Bolts
7/16” Nylon Locknuts
3/8” USS Flat Washers
6”
Suitable Structure
Diagram N
yes NO
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Commentaires sur ces manuels

Pas de commentaire