Aladdin-light-lift ALL700RM-CM Manuel d'utilisateur télécharger pdf (Page 4)

STEP 1

Determine mounting location of ALL700RM motor assembly. e ALL700RM may be mounted on an

angle, vertically, horizontally or upside down, if secured properly. See Diagram A.

Never install the ALL700RM where the ceiling height and total cable run through the pulleys exceeds

ve feet less than the exact length of winch cable. For example, if the ALL700RM is equipped with a

65ft. cable do not install the ALL700RM with a ceiling height and total cable run that is greater than

60ft. is could cause the cable to become reverse wrapped on the winch. An ALL700RM installed with

a reverse wrapped cable could cause the chandelier to fall, which could cause death, personal injury, and/

or property damage. Winch cable length can be found on the ALL700RM product sticker, shipping box,

and the front page of these installation instructions.

STEP 2

Determine mounting location of chandelier pulley assembly. Chandelier pulley assembly must be mounted

directly above where chandelier will hang. See Diagram B.

Never mount the chandelier pulley assembly o plane or unlevel in a remote installation. is could

cause the chandelier to fall, which could cause death, personal injury, and/or property damage. e

winch cable must hang plumb through the center of the top contact plate on the ceiling box.

Level

Upside Down

Left Angle

Right Angle

Vertical

Diagram A

Diagram B

Chandelier Pulley

Assembly Height is

Adjustable

From 12 ¾” to 17 ¾”

If Ordered With

Conduit Cut to

Minimum

Chandelier Pulley

Assembly Height is

Adjustable

From 8 ⅞” to 10 ⅜”

13 ¾” Minimum

16” Maximum

1 2 3 4 5 6 7 8 9 ... 21 22

Pas de commentaire

Aladdin-light-lift ALL700RM-CM Manuel d'utilisateur Page 4